Jump to content

to add your 300x250 banner, pay ad zone 5
Airsoft Atlanta is your source for quality airsoft guns and rifle parts
to add your Text Link here, pay ad zone 3

AirsoftAtlanta.com AirsoftNMore.com Airsplat.com AirsoftRC.com
Vote for us to add your 180x30 banner here, pay ad zone 2

If you appreciate this website, please ASF Donation or Check Out the ASF Store. If you can not help us financially,
then at least help us by telling a friend: Share us on your favorite social networking website Bookmark and Share

Groxter

Member
  • Content Count

    3
  • Joined

  • Last visited

  • Feedback

    N/A

Community Reputation

0 Neutral

About Groxter

  • Rank
    ASF Immigrant
  1. #Results# Cylinder changed to type 0: avg. 437fps achived. Shortened the SHS m120 by 2,5 coils resulting 401fps (I hope that the spring will loos the power over the time) -Lefse: I have alter the "mech box locking mechanism", from the back I have a bolt that pushes the mech box forward mounted in the plastic retainer. Thank you again for the input.
  2. Much appreciated, I will update you on outcomes
  3. Hello, I ran into the issue with AUG, full write up below. I own a ASG AUG A2, current setup: Shs m120, doube oring cylinder head, shaven tappet plate, metal nozzle with oring, metal hop-up (shimmed towards mech box), teflon on the bucking and, mad-bull 6.03 (509mm) = 330-338fps Previous spring operated when new at 345fps after 8 month gone down to 280. After instalation of M120 (longer than original, so no mistake here), guide and piston (aluminium) the fps did not achived expected 360-380fps. The original spring had a weight attached to the front of it, and the spring guide kept the back end of spring further away from the rear of mech box (pre-compression?). The New spring is not compatible with weight hence the heavier piston. I belive that system is not very leaky as fps is is rather consistent with odd anomaly +/- 10fps (hop-up: off) The mech box is shimmed and secured so sits snuggly with almost no play, hand compression test with the nozzle shows no leaks. When testes with piece of paper on the mag well bb feed, the piece of paper just moves to the side (not flying away). So far I came up with couple of ideas: -Air nozzle to short (0.5mm or something along this lines) -Lonex bucking not sealing under pressure(too soft?) -too light piston? -Too weak spring? -wrong cylinder volume (v3/4 I think) for this length of barell ( measurements to be perforemd over weekend). The cyliner is inserted with the notch on gearbox in right place. Could some point me in the right direction? Did I missed something obvious? Thank you for taking the time to read this.
×
×
  • Create New...