to add your 300x250 banner, pay ad zone 5
Airsoft Atlanta is your source for quality airsoft guns and rifle parts
to add your Text Link here, pay ad zone 3
to add your 180x30 banner here, pay ad zone 2
then at least help us by telling a friend: Share us on your favorite social networking website
Search the Community
Showing results for tags 'M120'.
The search index is currently processing. Current results may not be complete.
Found 2 results
I have a krytac spr mk 2 and I wanna put in a m120 or m125 spring. What is needed to make sure the gun wont break itself after the upgrade ? the bushings are metal atleast they look like it. So maybe a high torque motor and gears too ? idk it would be my first attempt at upgrading.
Hello, I ran into the issue with AUG, full write up below. I own a ASG AUG A2, current setup: Shs m120, doube oring cylinder head, shaven tappet plate, metal nozzle with oring, metal hop-up (shimmed towards mech box), teflon on the bucking and, mad-bull 6.03 (509mm) = 330-338fps Previous spring operated when new at 345fps after 8 month gone down to 280. After instalation of M120 (longer than original, so no mistake here), guide and piston (aluminium) the fps did not achived expected 360-380fps. The original spring had a weight attached to the front of it, and the spring guide kept the back end of spring further away from the rear of mech box (pre-compression?). The New spring is not compatible with weight hence the heavier piston. I belive that system is not very leaky as fps is is rather consistent with odd anomaly +/- 10fps (hop-up: off) The mech box is shimmed and secured so sits snuggly with almost no play, hand compression test with the nozzle shows no leaks. When testes with piece of paper on the mag well bb feed, the piece of paper just moves to the side (not flying away). So far I came up with couple of ideas: -Air nozzle to short (0.5mm or something along this lines) -Lonex bucking not sealing under pressure(too soft?) -too light piston? -Too weak spring? -wrong cylinder volume (v3/4 I think) for this length of barell ( measurements to be perforemd over weekend). The cyliner is inserted with the notch on gearbox in right place. Could some point me in the right direction? Did I missed something obvious? Thank you for taking the time to read this.