Jump to content
Sign in to follow this  
kamikazefighta6000

How Do I Open Stock Cylinder?

Recommended Posts

I hear a lot about how crappy the zero trigger o-ring is. Well thats what I have in my gun right now and I would've put the stock o-ring in but I can't get the cap off of the stock cylinder. I tried drilling into the pin but after about 15 minutes or so of drilling, it seemed like I was getting nowhere. Any suggestions?

Share this post


Link to post
Share on other sites

If you really don't care much about the stock cylinder then you could hack saw the cylinder heads off by sawing a bit below the cylinder head directly on the cylinder head. You could still salvage everything inside except for the cylinder itself - Just something to think about. Although I would say that just bringing the piston head to the hardware store and test fitting O-rings (Although X-rings seal better and are almost as cheap) until you find the one that fits perfectly would be the easiest thing to do.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...